MSDP Configuration Commands 647
[SW8800] msdp
[3Com-msdp] peer 110.10.10.1 minimum-ttl 10
peer request-sa-enable Syntax
peer peer-address request-sa-enable
undo peer peer-address request-sa-enable
View
MSDP view
Parameter
peer-address: Address of MSDP peer.
Description
Use the peer request-sa-enable command to enable the router to send SA
request message to the specified MSDP peer when receiving a new group join
message.
Use the undo peer request-sa-enable command to remove the configuration.
By default, when receiving a new group join message, the router sends no SA
request messages to MSDP peers but waits to receive the next SA message.
Related command: cache-sa-enable.
Example
# Configure to send SA request message to the MSDP peer 125.10.7.6.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] msdp
[3Com-msdp] peer 125.10.7.6 request-sa-enable
peer sa-cache-maximum Syntax
peer peer-address sa-cache-maximum sa-limit
undo peer peer-address sa-cache-maximum
View
MSDP view
Parameter
peer-address: Address of MSDP peer.
sa-limit: Maximum value that the SA cache allows, ranging from 1 to 2048.
Description
Use the peer sa-cache-maximum command to limit the number of caches
originated when the router receives SA messages from an MSDP peer.
To Next Page
Loading...
