3Com 8807 - Peer Vpn-Instance Route-Policy Import; Policy Vpn-Target

746 CHAPTER 40: BGP/MPLS VPN CONFIGURATION COMMANDS
Example
# Add a CE neighbor to a peer group.
[3Com-bgp] ipv4-family vpn-instance vrf1
[3Com-bgp-af-vpn-instance] peer 1.1.1.1 group ebgp as-number 600
[3Com-bgp-af-vpn-instance] quit
[3Com-bgp] ipv4-family vpnv4
[3Com-bgp-af-vpn] peer 1.1.1.1 vpn-instance vrf1 group ebgp
peer vpn-instance
route-policy import
Syntax
peer { peer-address | group-name } vpn-instance vpn-instance-name
route-policy policy-name import
undo peer { peer-address | group-name } vpn-instance vpn-instance-name
route-policy policy-name import
View
BGP-VPNv4 sub-address family view
Parameter
peer-address: IP address of a peer, in dotted decimal.
group-name: Name of a peer group.
vpn-instance-name: Name of the VPN instance the CE peer belongs to.
policy-name: Name of the routing policy to be applied.
Description
Use the peer vpn-instance route-policy import command to configure the
routing policy applied by the CE peer to VPNv4 routes it received.
Use the undo peer vpn-instance route-policy import command to cancel the
configuration.
By default, no routing policy is configured.
The ingress routing policy configured for a peer takes precedence over the
configuration for the peer group.
Example
# Configure the peer group ebgp to apply the routing policy named comtest to
the ingress routes.
[3Com-bgp-af-vpn] peer ebgp vpn-instance vrf1 route-policy comtest import
policy vpn-target Syntax
policy vpn-target
undo policy vpn-target
View
BGP-VPNv4 sub-address family view