3Com 8807 - Info-Center Console Channel

Information Center Configuration Commands 1009
channel-name: Specifies the channel name with a character string not exceeding
30 characters, excluding digit, "-", "/" or "". .
Description
Use the info-center channel name command to rename a channel specified by
the channel-number as channel-name.
Use the undo info-center channel command to restore the channel name.
The system assigns a channel in each output direction by default. See the table
below.
Note that the channel name cannot be duplicated.
Example
# Rename the channel 0 as execconsole.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] info-center channel 0 name execconsole
info-center console
channel
Syntax
info-center console channel { channel-number | channel-name }
undo info-center console channel
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name: Specifies the channel name. The name can be channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,
trapbuffer, logfile.
Description
Use the info-center console channel command to configure the channel
through which the log information is output to the console.
Tab le 144 Numbers and names of the channels for log output
Output direction Channel number Default channel name
Console 0 console
Monitor 1 monitor
Info-center loghost 2 loghost
Trap buffer 3 trapbuf
Logging buffer 4 logbuf
snmp 5 snmpagent
Log file 6 Logfile