HA Configuration Commands 803
Description
Use the slave auto-update config command to enable automatic
synchronization between the master and slave systems.
Use the undo slave auto-update config command to disable automatic
synchronization between the master and slave systems.
By default, automatic synchronization is enabled.
Related command: slave update config.
Example
# Enable automatic synchronous switch between master/slave systems.
[SW8800] slave auto-update config
slave restart Syntax
slave restart
View
User view
Parameter
None
Description
Use the slave restart command to restart slave fabric.
When the slave system works abnormally, and needs to be reloaded, you can use
this command to restart the slave fabric.
Example
# Implement the restart of the slave system.
<SW8800> slave restart
The slave will reset! Continue?[Y/N]:y
slave switchover Syntax
slave switchover
View
User view
Parameter
None
Description
Use the slave switchover command to start the master-slave switchover
manually.
In the environment in which the slave fabric is available and master in real-time
backup state, the user can inform the slave fabric of a master-slave switchover by
To Next Page
Loading...
