SNMP Configuration Commands 915
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] snmp-agent trap source vlan-interface 1
snmp-agent usm-user Syntax
snmp-agent usm-user { v1 | v2c } username groupname [ acl acl-list ]
undo snmp-agent usm-user { v1 | v2c } username groupname
snmp-agent usm-user v3 username groupname [ authentication-mode { md5
| sha } authpassstring [ privacy-mode { des56 privpassstring } ] ] [ acl acl-list ]
undo snmp-agent usm-user v3 username groupname { local | engineid
engine-id }
View
System view
Parameter
v1: Configures to use V1 safe mode.
v2c: Configures to use V2c safe mode.
v3: Configures to use V3 safe mode.
username: Specifies the user name, ranging from 1 to 32 bytes.
groupname: Specifies the group name corresponding to that user, a character
string at the length ranging from 1 to 32 bytes.
authentication-mode: Specifies the safety level as authentication required.
md5: MD5 algorithm is adopted in authentication. MD5 authentication uses the
128-digit password. Computation speed of MD5 is faster than that of SHA
sha: SHA algorithm is adopted in authentication. SHA authentication uses the
160-digit password. Computation speed of SHA is slower than that of MD5, but
with higher security.
authpasstring: Specifies the authentication password with a character string,
ranging from 1 to 64 bytes.
privacy-mode: Specifies the safety level as encrypted.
des56: Specifies the authentication protocol as DES.
privpassword: Specifies the encryption password with a character string, ranging
from 1 to 64 bytes.
acl acl-list: Sets access control list for this user based on USM name
engineid engine-id: SNMP engineID.
To Next Page
Loading...
