3Com 8807 - Display Isis Spf-Log

468 CHAPTER 26: INTEGRATED IS-IS CONFIGURATION COMMANDS
View
Any view
Parameter
None
Description
Use the display isis route command to view IS-IS routing information. .
Example
# View IS-IS routing information.
<SW8800> display isis route
ISIS Level - 1 Forwarding Table :
Type - D -Direct, C -Connected, I -ISIS, S -Static, O -OSPF
B -BGP, R -RIP
Flags: R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
Destination/Mask In.Met Ex.Met NextHop Interface Flags
--------------------------------------------------------------------------
I 3.3.3.0/24 20 7.7.7.7 Vlan-interface1000 R/-/-
6.6.6.6 Vlan-interface1001
I 0.0.0.0/0 10 7.7.7.7 Vlan-interface1000 R/-/-
6.6.6.6 Vlan-interface1001
D 7.7.7.0/25 10 Direct Vlan-interface1000 R/L/-
D 6.6.6.0/24 10 Direct Vlan-interface1001 R/L/-
I 10.1.1.0/24 10 7.7.7.7 Vlan-interface1000 R/-/-
6.6.6.6 Vlan-interface1001
display isis spf-log Syntax
display isis spf-log
View
Any view
Parameter
None
Description
Use the display isis spf-log command to view the SPF calculation log information
of the IS-IS. .
Example
# View the SPF calculation log of IS-IS.
<SW8800> display isis spf-log
Details of Level 1 SPF Run:
-------------------------------------------------------------------------
Trig.Event No.Of Nodes Duration(ms) StartTime
IS_SPFTRIG_LSPCHANGE 2 19 1:12:1
IS_SPFTRIG_LSPCHANGE 2 19 1:11:58
IS_SPFTRIG_LSPCHANGE 2 18 1:11:53
IS_SPFTRIG_CIRC_DOWN 2 19 1:11:46
IS_SPFTRIG_NEWADJ 2 20 1:11:39
IS_SPFTRIG_LSPCHANGE 2 19 1:11:35
IS_SPFTRIG_PERIODIC 3 18 1:3:25