548 CHAPTER 28: IP ROUTING POLICY CONFIGURATION COMMANDS
[3Com-route-policy] apply as-path 200
apply community Syntax
apply community [ aa:nn ]* [ [ no-export-subconfed | no-export |
no-advertise ] * [ additive ] | additive | none ]
undo apply community
View
Route policy view
Parameter
none: Deletes the community attribute of the route. This keyword can be input up
to 13 times.
aa:nn: Community number.
no-export-subconfed: Does not send matched route outside the sub-AS.
no-advertise: Does not send matched route to any peer.
no-export: Does not advertise the route to outside the AS or the confederation,
but can advertises to other sub-Ass in the confederation.
additive: Community attribute of the additive route.
Description
Use the apply community command to configure the set BGP community
attribute of Route-policy.
Use the undo apply community command to cancel the set BGP community
attribute.
By default, BGP community attribute is not set.
If the matching conditions defined in the Route-policy are satisfied, the BGP
community attribute is set.
Related command: ip community-list, if-match community-list, route-policy,
display bgp routing-table community.
Example
# Configure one Route-policy setcommunity, whose node serial number is 16 and
match mode is permit, and enter Route policy view to set match conditions and
attribute modification actions to be executed.
[SW8800] route-policy permit node 16
[3Com-route-policy] if-match as-path 8
[3Com-route-policy] apply community no-export
apply cost Syntax
apply cost value
To Next Page
Loading...
