MBGP Multicast Extension Configuration Commands 671
acl-number: Number of IP ACL, ranging from 2000 to 3999. That is, you can use
basic ACLs or advanced ACLs.
Description
Use the peer filter-policy import command to configure the peer to apply the
ACL-based filter policy to the received routes.
Use the undo peer filter-policy import command to cancel the existing
configuration.
By default, no ACL-based filter policy is configured.
Related command: peer filter-policy export, acl.
The inbound filter policy configured for the peer takes precedence over the
configurations for the peer group.
Example
# Configure the peer group test to use ACL 2000 to filter the received routes.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] peer test filter-policy 2000 import
peer group Syntax
peer peer-address group group-name
undo peer peer-address
View
IPv4 multicast sub-address family view
Parameter
peer-address: IP address of the peer, in dotted decimal format.
group-name: Name of the peer, consisting of one to 47 alphanumeric characters.
Description
Use the peer group command to add a peer into a peer group.
Use the undo peer group command to delete the peer.
c
CAUTION: You must first add the specific peer in the peer group in BGP view and
enable the peer group in the IPv4 multicast sub-address family view before you
can issue this command.
Example
# Add peer 10.1.1.1 to EBGP peer group TEST.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
To Next Page
Loading...
