3Com 8807 - Display Pim Routing-Table

PIM Configuration Commands 625
Parameter
interface interface-type interface-number: Interface type and interface number,
used to specify the interface.
Description
Use the display pim neighbor command to view the PIM neighbor information
discovered by the switch interface. If the interface type and interface number are
specified, this command only displays the PIM neighbor information on the
specified interface.
Example
# Display PIM neighbor information discovered by the switch interface.
<SW8800> display pim neighbor
Neighbor’s Address Interface Name Uptime Expires
90.0.0.2 Vlan-interface90 00:00:36 00:01:40
display pim
routing-table
Syntax
display pim routing-table [ { { *g [ group-address [ mask { mask-length | mask }
] ] | **rp [ rp-address [ mask { mask-length | mask } ] ] } | { group-address [ mask {
mask-length | mask } ] | source-address [ mask { mask-length | mask } ] } * } |
incoming-interface { interface interface-type interface-number | null } | {
dense-mode | sparse-mode } ] *
View
Any view
Parameter
*g: (*, G) route entry.
mask: IP address mask.
mask-length: Length of the IP address mask.
**rp: (*, *, p) route entry.
rp-address: Address of the RP.
group-address: Address of the multicast group.
source-address: IP address of the multicast source.
incoming-interface interface interface-type interface-number: Route entry with
the specified incoming interface.
Tab le 89 Description on the fields of display pim neighbor command
Field Description
Neighbor
Address
Neighbor address
Interface Interface where the neighbor has been discovered
Uptime Time passed since the multicast group has been discovered
Expires Specifies when the member will be removed from the group