3Com 8807 - Lsp-Trigger; Display Mpls Statistics

684 CHAPTER 39: MPLS BASIC CONFIGURATION COMMANDS
NO FEC NEXTHOP I/O-LABEL OUT-INTERFACE
1 1.1.1.1/32 200.5.5.4 -----/1000 Vlan2000
TOTAL: 1 Record(s) Found.
display mpls statistics Syntax
display mpls statistics { interface { Vlan-interface | all } | lsp { lsp-Index | all |
lsp-name }}
View
Any view
Parameter
interface { Vlan-interface | all }: Specifies one interface or all interfaces.
lsp { lsp-Index | all | lsp-name }: Specifies one label switching path or all label
switching paths. Where lsp-Index is an LSP index, lsp-name is an LSP name, and all
represents all LSPs.
Description
Use the display mpls statistics command to view the MPLS statistics about one
specific VLAN interface/LSP or all interfaces/LSPs.
Related command: display mpls interface and display mpls lsp.
Example
# Display MPLS statistics about all LSPs
<SW8800> display mpls statistics lsp all
Building the information...
LSP Index/LSP Name : 10240/dynamic-lsp
There is no information of LSP incoming segment!
The statistics of lsp Out :
OutSegment octets of LSP is: 162876
OutSegment packets of LSP is: 2943
OutSegment errors of LSP is: 0
OutSegment discard packets of LSP is: 0
lsp-trigger Syntax
lsp-trigger { all | ip-prefix ip-prefix }
undo lsp-trigger { all | ip-prefix ip-prefix }
View
MPLS view
Parameter
all: Triggers LSPs at any route.
ip-prefix: Triggers LSPs only at the routes matching the specified IP prefix list.
ip-prefix: IP prefix list, ranging from 1 to 19.