706 CHAPTER 39: MPLS BASIC CONFIGURATION COMMANDS
[3Com-Vlan-interface201] mpls ldp transport-ip 10.1.11.2
remote-ip Syntax
remote-ip remoteip
View
remote-peer view
Parameter
remoteip: IP address of the Remote-peer.
Description
Use the remote-ip command to configure a Remote-IP address. The address
should be the lsr-id of the remote LSR. As Remote Peers adopt LSR ID as their
transport addresses, the last two Remote Peers use the lsr-id as their transport
addresses for creating TCP connection.
Related command: mpls ldp remote-peer.
Example
# Configure the address of remote-peer.
<SW8800> system-view
[SW8800] mpls ldp remote-peer 12
[3Com-mpls-remote12] remote-ip 192.168.1.1
To Next Page
Loading...
