3Com 8807 - Reset Garp Statistics; Display Gvrp Statistics

124 CHAPTER 9: GARP&GVRP CONFIGURATION COMMANDS
After every GARP application entity is started, the LeaveAll timer will be started
simultaneously. The GARP application entity will send LeaveAll message after the
timer times out to make other application entities re-register all attribute
information on the entities themselves. Then, the LeaveAll timer is started and the
new cycle begins.
Related command: display garp timer.
Example
# Set GARP LeaveAll timer to 1s.
[SW8800] garp timer leaveall 100
reset garp statistics Syntax
reset garp statistics [ interface interface-list ]
View
User view
Parameter
interface-list: Specifies a list of Ethernet ports on which the GARP statistics
information will be cleared, expressed as interface-list = { interface-type
interface-number [ to interface-type interface-num] }&<1-10>. interface-type is
interface type, and interface-number is interface number. The interface-number
after the keyword to must be larger than or equal to that before to. &<1-10>
means that the preceding parameter can be repeated up to 10 times.
Description
Use the reset garp statistics command to reset the GARP statistics information
(such as the packets received/sent and discarded by GVRP/GMRP). If the command
has no parameter, it will clear the GARP statistics information of all the ports.
Related command: display garp statistics.
Example
# Clear GARP statistics information.
<SW8800> reset garp statistics
GVRP Configuration
Commands
display gvrp statistics Syntax
display gvrp statistics [ interface interface-list ]
View
Any view
Parameter
Interface-list: List of Ethernet ports on which the GVRP statistics information is to
be displayed, expressed as interface-list = { interface-type interface-number } [ to