3Com 8807 - Debugging; Close

FTP Client Commands 993
View
FTP Client view
Parameter
None
Description
Use the cdup command to change working path to the upper level directory.
This command is used to exit the current directory and return to the upper level
directory.
Example
# Change working path to the upper level directory.
<SW8800> ftp
[ftp] cdup
close Syntax
close
View
FTP Client view
Parameter
None
Description
Use the close command to disconnect FTP client side from FTP server side without
exiting FTP client side view. That is to say, you can terminate the control
connection and data connection with the remote FTP Server at the same time.
Example
# Terminate connection with the remote FTP Server and stays in FTP Client view.
<SW8800> ftp
[ftp] close
debugging Syntax
debugging
undo debugging
View
FTP Client view
Parameter
None
Description
Use the debugging command to enable the debugging for FTP Client commands.