3Com 8807 - Info-Center Loghost

1012 CHAPTER 60: INFORMATION CENTER
This command takes effect only after the system logging is enabled.
Related command: info-center enable, display info-center.
Example
# Send log information to logfile.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] info-center logfile
info-center loghost Syntax
info-center loghost { source interface-type interface-number | host-ip-addr [
channel { channel-number | channel-name } | facility local-number | language {
chinese | english } ]*}
undo info-center loghost host-ip-addr
View
System view
Parameter
host-ip-addr: IP address of info-center loghost.
channel: Configures information channel of the info-center loghost.
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name: Specifies the channel name. The name can be channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,
trapbuffer, logfile.
Source: Source address of the packet sent to the loghost.
interface-type interface-number: Type and number of interface sending log file.
facility: Configures the recording tool of info-center loghost.
local-number: Record tool of info-center loghost, ranging from local0 to local7.
language: Sets the logging language.
chinese,english: Language used in log file.
Description
Use the info-center loghost command to configure the system to output
information to the log host.
Use the undo info-center loghost command to cancel output to info-center
loghost.
By default, Ethernet switches do not output information to info-center loghost.