3Com 8807 - Wred

274 CHAPTER 17: QOS COMMANDS
wred Syntax
wred wred-index
undo wred wred-index
View
System view
Parameter
wred-index: WRED index, in the range of 0 to 3.
Description
Use the wred command to create a WRED index view and enter it.
Use the undo wred command to restore the default WRED parameters.
The switch provides four sets of default WRED parameters, respectively numbered
as 0, 1, 2 and 3. The ten parameters for a port are green-min-threshhold,
yellow-min-threshhold, red-min-threshhold, green-max-threshhold,
yellow-max-threshhold, red-max-threshhold, green-max-prob, yellow-max-prob,
red-max-prob and exponent. Red, yellow and green packets respectively refer to
those with drop precedent levels 2, 1 and 0.
Example
# Create WRED 0 view and enter it.
[SW8800] wred 0
[3Com-wred-0]