736 CHAPTER 40: BGP/MPLS VPN CONFIGURATION COMMANDS
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
peer-address: Peer IP address, in dotted decimal notation.
acl-number: IP ACL number from 2000 to 3999, that is, you can use basic or
advanced ACL.
import: Performs the filtering policy on the received routes.
Description
Use the peer filter-policy import command to apply the ACL-based filtering
policy to the received routing information for peers.
Use the undo peer filter-policy import command to cancel the application.
By default, there is no ACL-based filtering policy.
Related command: ip as-path-acl and peer as-path-acl.
The incoming filtering policy configured for peers take precedence over the
configuration for peer groups.
Example
# Configure the test peer group to filter the received route with ACL 3000.
[3Com-bgp] ipv4-family vpnv4
[3Com-bgp-af-vpn] peer test filter-policy 3000 import
peer group Syntax
peer peer-address group group-name [ as-number as-number ]
undo peer peer-address
View
VPNv4 sub-address family view, VPN-instance sub-address family view
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
peer-address: Peer IP address in dotted decimal notation.
as-number: Peer AS number in the range of 1 to 65535. This parameter is only
effective in the BGP view and VPN-instance sub-address family view.
Description
Use the peer group command to add a peer to an existing peer group.
Use the undo peer command to delete a specified peer from the group.
To Next Page
Loading...
