3Com 8807 - Vlan-Vpn Enable

148 CHAPTER 10: ETHERNET PORT CONFIGURATION COMMANDS
By default, the speed is auto.
Related command: duplex.
Example
# Configure Ethernet port Ethernet2/1/1 port speed as 100 Mbps.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] interface Ethernet2/1/1
[3Com-Ethernet2/1/1] speed 100
vlan-vpn enable Syntax
vlan-vpn enable
undo vlan-vpn
View
Ethernet port view
Parameter
None
Description
Use the vlan-vpn enable command to enable port VLAN VPN.
Use the undo vlan-vpn command to disable port VLAN VPN.
Note that if anyone of GComware, STP, NTP or 802.1x has been enabled on a
port, VLAN VPN cannot be enabled on it.
By default, the port VLAN VPN is disabled.
Example
# Enable VLAN VPN on Ethernet2/1/1.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] interface Ethernet2/1/1
[3Com-Ethernet2/1/1] vlan-vpn enable