3Com 8807 - Summary

MBGP Multicast Extension Configuration Commands 679
Example
# Specify cluster ID for local router, one of the router reflectors.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] reflector cluster-id 80
[3Com-bgp-af-mul] peer test reflect-client
summary Syntax
summary
undo summary
View
IPv4 multicast sub-address family view
Parameter
None
Description
Use the summary command to set to auto-aggregate subnet routes.
Use the undo summary command to remove the configuration.
By default, subnet routes cannot be aggregated automatically.
After the summary command is executed, MBGP cannot receive the subnet
routes imported by IGP. You can use this command to reduce route selection
information.
Example
# Enable subnet route auto-aggregation.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] summary