HWTACACS Configuration Commands 363
You can remove a TACACS scheme accounting server only when no Active TCP
connection used to send accounting packets is now using the server, and the
removal impacts only packets forwarded afterwards.
Example
# Configure a secondary accounting server.
[SW8800] hwtacacs scheme test1
[3Com-hwtacacs-test1] secondary accounting 10.163.155.12 49
secondary
authentication
Syntax
secondary authentication ip-address [ port-number ]
undo secondary authentication
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
format.
port-number: Port number of the server, which is in the range 1 to 65535 and
defaults to 49.
Description
Use the secondary authentication command to configure a secondary TACACS
authentication server.
Use the undo secondary authentication command to delete the configured
secondary authentication server.
By default, IP address of TACACS authentication server is all zeros.
You are not allowed to assign the same IP address to both primary and secondary
authentication servers.
If you repeatedly use this command, the latest configuration overwrites the
previous one.
You can remove a TACACS scheme authentication server only when no Active TCP
connection used to send authentication packets is now using the server, and the
removal impacts only packets forwarded afterwards.
Related command: display hwtacacs.
Example
# Configure a secondary authentication server.
[SW8800] hwtacacs scheme test1
[3Com-hwtacacs-test1] secondary authentication 10.163.155.13 49
To Next Page
Loading...
