3Com 8807 - Peer Advertise-Community; Peer Allow-As-Loop

728 CHAPTER 40: BGP/MPLS VPN CONFIGURATION COMMANDS
[SW8800] ospf 100 router-id 2.2.2.2 vpn-instance vpn1
[3Com-ospf-100]
peer
advertise-community
Syntax
peer group-name advertise-community
undo peer group-name advertise-community
View
VPNv4 sub-address family view, VPN-instance sub-address family view
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
Description
Use the peer advertise-community command to configure to transmit the
community attributes to a specified peer group.
Use the undo peer advertise-community command to cancel this
configuration.
By default, the BGP advertiser does not transmit the community attributes to peer
group.
Related command: if-match community-list and apply community.
Example
# Transmit the community attributes to the peer group test.
[3Com-bgp] ipv4-family vpnv4
[3Com-bgp-af-vpn] peer test advertise-community
peer allow-as-loop Syntax
peer { group-name | peer-address } allow-as-loop [asn-limit]
undo peer { group-name | peer-address } allow-as-loop
View
VPNv4 sub-address family view, VPN-instance sub-address family view
Parameter
group-name: Name of a peer group, consisting of 1 to 47 alphanumeric
characters.
peer-address: IP address of a specified peer.
asn-limit: Maximum times for which autonomous system (AS) number is allowed
to receive in route updates.