3Com 8807 - Display Isis Lsdb; Display Isis Mesh-Group

466 CHAPTER 26: INTEGRATED IS-IS CONFIGURATION COMMANDS
Priority : L1 64 L2 64
Retransmission interval : 5
display isis lsdb Syntax
display isis lsdb [ [ l1 | l2 | level-1 | level-2 ] | [ [ LSPID | local ] | verbose ]* ]*
View
Any view
Parameter
l1 and Level-1: Both refer to the link state database of Level-1.
l2 and level-2: Both refer to the link state database of Level-2.
LSPID: Specifies the LSPID of the Network-entity-title.
local: Displays the LSP information generated locally.
verbose: Configures to display the verbose information of the link state database.
Description
Use the display isis lsdb command to view the link state database of the IS-IS.
Example
# Display the information of an LSP.
<SW8800> display isis lsdb 0050.0500.5005.00-00
IS-IS Level-1 Link State Database
Lsp ID Sequence Holdtime A_P_O Checksum
>0050.0500.5005.00-00 0x00000328 780 0_0_0 0xf211
display isis mesh-group Syntax
display isis mesh-group
View
Any view
Parameter
None
Description
Use the display isis mesh-group command to view the IS-IS mesh group.
This command is used for displaying the configurations of the mesh-group of the
current router interface.
Example
# Add Interface Vlan-interface 10 and Interface Vlan-interface 20 running IS-IS
into mesh group 100.