QoS Commands 245
display qos-vlan
traffic-redirect
Syntax
display qos-vlan [ vlan-id ] traffic-redirect
View
Any view
Parameter
vlan-id: ID of a VLAN, in the range of 1 to 4094.
Description
Use the display qos-vlan traffic-redirect command to display the parameter
configuration for traffic redirection in VLAN, including the related ACL and the
destination port of the traffic redirection.
Related command: traffic-redirect.
Example
# Display the parameter configuration for a traffic redirection in VLAN.
<SW8800> display qos-vlan 2 traffic-redirect
Vlan 2 traffic-redirect
Inbound:
Matches: Acl 2000 rule 1 running (Action-type: Eacl, Destination slot: 3)
Redirected to: next-hop 1.1.1.1
Outbound:
There is no configuration.
display qos-vlan
traffic-statistic
Syntax
display qos-vlan [ vlan-id ] traffic-statistic
View
Any view
Parameter
vlan-id: VLAN ID, in the range of 1 to 4,094
Description
Use the display qos-vlan traffic-statistic command to display the traffic
statistics information in VLAN. The displayed information includes the ACL
corresponding to the traffic flow to be output, action type, and statistics result.
Related command: traffic-statistic.
Example
# Display the traffic statistics information of VLAN 2.
<SW8800> display qos-vlan 2 traffic-statistic
Vlan 2 traffic-statistic
Inbound:
Matches: Acl 3000 rule 0 running (Action-type: Vlan-acl)
0 byte (green 0 byte(s), yellow 0 byte(s), red 0 byte(s) )
0 packet
Matches: Acl 3000 rule 0 running (Action-type: Eacl, Destination slot: 2)
0 byte
Outbound:
To Next Page
Loading...
