3Com 8807 - Peer Route-Policy Import

742 CHAPTER 40: BGP/MPLS VPN CONFIGURATION COMMANDS
View
VPNv4 sub-address family view, VPN-instance sub-address family view
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
policy-name: Name of a routing policy.
Description
Use the peer route-policy export command to apply the routing policy to peer
group for advertised routing information.
Use the undo peer route-policy export command to cancel the configuration.
By default, there is no routing policy.
The peer route-policy export command is only used to configure peer groups.
Related command: peer route-policy import.
Example
# Apply the routing policy test-policy to the outgoing routes of the peer group
test.
[3Com-bgp] ipv4-family vpnv4
[3Com-bgp-af-vpn] peer test route-policy test-policy export
peer route-policy import Syntax
peer { group-name | peer-address } route-policy policy-name import
undo peer { group-name | peer-address } route-policy policy-name import
View
VPNv4 sub-address family view, VPN-instance sub-address family view
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
peer-address: Peer IP address in dotted decimal notation.
policy-name: Name of the applied routing policy.
Description
Use the peer route-policy import command to apply a routing policy to peer for
received routing information.
Use the undo peer route-policy import command to delete the setting.
By default, there is no routing policy.