3Com 8807 - Display Port-Group Index; Display Port-Group

17
QOS COMMANDS
QoS Commands
c
CAUTION:
After QACL is configured in port view, the QACL configuration of all the member
ports in the port group keeps the same all the time. After a port is added to the
port group, the port configuration is overwritten by that of the port group. You
cannot apply the ACL rule as per port.
display port-group Syntax
display port-group
View
Any view
Parameter
None
Description
Use the display port-group command to display all the port groups in the
current system.
Related command: port-group
Example
# Display the port groups in the current system.
<SW8800> display port-group
Now, the following port group exist(s): 1
display port-group index Syntax
display port-group index
View
Any view
Parameter
index: Number of the designated port.