3Com 8807 - Link-Aggregation Group Agg-ID Description

Ethernet Link Aggregation Configuration Commands 157
interface-name2: Last range value of Ethernet port joined the Ethernet link
aggregation.
both: Specifies the aggregation group to balance load for inbound and outbound
packets.
Description
Use the link-aggregation command to configure a series of ports to aggregation
port.
Related command: link-aggregation group agg-id mode, port
link-aggregation group.
n
When a port is added into an aggregation group, the original ARP information of
the port will be lost.
Example
# Configure to balance load for inbound and outbound packets.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] link-aggregation ethernet2/1/1 to ethernet2/1/2 both
link-aggregation group
agg-id description
Syntax
link-aggregation group agg-id description alname
undo link-aggregation group agg-id description
View
System view
Parameter
agg-id: Aggregation group ID, in the range of 1 to 920. IDs 1 though 31 indicate
manual or static aggregation groups; IDs 32 through 64 are reserved; IDs 65
though 192 indicate Routed Trunks; IDs 193 through 920 indicate dynamic
aggregation groups.
alname: Aggregation group name, character string with 1 to 32 characters.
Description
Use the link-aggregation group agg-id description command to configure
description for an aggregation group.
Use the undo link-aggregation group agg-id description command to delete
aggregation group description.
Note that you cannot configure the description for a dynamic aggregation group.
Related command: display link-aggregation verbose.
Example
# Configure myal1 as the description of aggregation group 22.