3Com 8807 - Display Vlan-Ip Vlan

IP Subnet-Based VLAN Configuration Commands 87
mode: Specifies the VLAN based on other protocols.
The following protocols can be supported:
all: Supports all the protocols.
Description
Use the protocol-vlan command to specify the parameters of VLANs based on
AppleTalk, IPX, and so on.
Use the undo vlan-type protocol command to cancel this configuration.
Related command: display protocol-vlan vlan.
Example
# Specify VLAN 5 based on AppleTalk.
[3Com-vlan5] protocol-vlan at
IP Subnet-Based VLAN
Configuration
Commands
display vlan-ip vlan Syntax
display vlan-ip vlan { vlan-list | all }
View
Any view
Parameter
vlan-list: Displays the information of a specified IP subnet-based VLAN, in the form
of vlan-list = { vlan-id [ to vlan-id ] }.
all: Displays the protocol information and indexes of all the IP subnet-based
VLANs.
Protocol mode Parameter Description
Ethernet II-based VLAN ethernetii etype etype-id etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
llc dsap dsap-id ssap ssap-id dsap-id: Indicates a
destination service access
point, in the range of 0 to FF
ssap-id: Indicates a source
service access point, in the
range of 0 to FF
SNAP-based protocol snap etype etype-id etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF