3Com 8807 - Apply Ip Next-Hop; Apply Isis

550 CHAPTER 28: IP ROUTING POLICY CONFIGURATION COMMANDS
[3Com-route-policy] apply cost-type internal
apply ip next-hop Syntax
apply ip next-hop ip-address
undo apply ip next-hop
View
Route policy view
Parameter
ip-address: The next-hop address.
Description
Use the apply ip next-hop command to configure the next hop address in the
route information.
Use the undo apply ip next-hop command to cancel the Apply sub-statement.
By default, no Apply sub-statement is defined.
This command is one of the Apply sub-statements of Route-policy. When it is used
for setting route information attribute, it sets the next hop address area of route
information passing filtration.
Related command: if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply
local-preference, apply cost, apply origin, apply tag.
Example
# Define an Apply sub-statement. Set the next hop address of route information as
193.1.1.8 when it is used for setting route information attribute.
[3Com-route-policy] apply ip next-hop 193.1.1.8
apply isis Syntax
apply isis [ level-1 | level-2 | level-1-2 ]
undo apply isis
View
Route policy view
Parameter
level-1: Sets to import the matched route to Level-1 area.
level-2: Sets to import the matched route to Level-2 area.
level-1-2: Sets to import the matched route to both Level-1 and Levle-2 area.