3Com 8807 - Idle-Timeout; Language-Mode

52 CHAPTER 2: COMMANDS USED TO LOG IN TO SWITCH
[SW8800] user-interface aux 0
[3Com-ui-aux0] history-command max-size 20
idle-timeout Syntax
idle-timeout minutes [ seconds ]
undo idle-timeout
View
User interface view
Parameter
minutes: Specifies the minute, ranging from 0 to 35791.
seconds: Specifies the second, ranging from 0 to 59.
Description
Use the idle-timeout command to configure the timeout function. If there is no
user operation performed before idle-timeout expires, the user interface will be
disconnected.
Use the undo idle-timeout command to restore the default idle-timeout.
idle-timeout 0 means disabling idle-timeout.
By default, idle-timeout is set to 10 minutes.
Example
# Configure the timeout value to 1 minute on the AUX user interface.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] user-interface aux 0
[3Com-ui-aux0] idle-timeout 1 0
language-mode Syntax
language-mode { chinese | english }
View
User view
Parameter
chinese: Configures the language environment of command line interface as
Chinese.
english: Configures the language environment of command line interface as
English.
Description
Use the language-mode command to switch between different language
environments of command line interface for convenience of different users.