3Com 8807 - Pim Neighbor-Policy

630 CHAPTER 36: PIM CONFIGURATION COMMANDS
[SW8800]interface vlan-interface 10
[3Com-Vlan-interface10] pim neighbor-limit 50
pim neighbor-policy Syntax
pim neighbor-policy acl-number
undo pim neighbor-policy
View
Interface view
Parameter
acl-number: Basic ACL number, in the range of 2000 to 2999.
Description
Use the pim neighbor-policy command to set to filter the PIM neighbors on the
current interface.
Use the undo pim neighbor-policy command to remove the setting.
Only the routers that match the filtering rule in the ACL can serve as a PIM
neighbor of the current interface.
The new configuration overwrites the old one if you run the command for a
second time.
Example
# Configure that 10.10.1.2 can serve as a PIM neighbor of the Vlan-interface10,
but not 10.10.1.1.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800]interface vlan-interface 10
[3Com-Vlan-interface10] pim neighbor-policy 2000
[3Com-Vlan-interface10] quit
[SW8800] acl number 2000
[3Com-acl-basic-2000] rule permit source 10.10.1.2 0
[3Com-acl-basic-2000] rule deny source 10.10.1.1 0
pim sm Syntax
pim sm
undo pim sm
View
Interface view
Parameter
None
Description
Use the pim sm command to enable the PIM-SM protocol on an interface.