3Com 8807 - Display Stop-Accounting-Buffer Hwtacacs-Scheme

HWTACACS Configuration Commands 355
Related command: hwtacacs scheme.
Example
# Display the configuration information of the HWTACACS scheme gy.
<SW8800> display hwtacacs gy
------------------------------------------------------------------
HWTACACS-server template name : gy
Primary-authentication-server : 172.31.1.11:49
Primary-authorization-server : 172.31.1.11:49
Primary-accounting-server : 172.31.1.11:49
Secondary-authentication-server : 0.0.0.0:0
Secondary-authorization-server : 0.0.0.0:0
Secondary-accounting-server : 0.0.0.0:0
Current-authentication-server : 172.31.1.11:49
Current-authorization-server : 172.31.1.11:49
Current-accounting-server : 172.31.1.11:49
Source-IP-address : 0.0.0.0
key authentication : 790131
key authorization : 790131
key accounting : 790131
Quiet-interval(min) : 5
Response-timeout-Interval(sec) : 5
Domain-included : No
Traffic-unit : B
Packet traffic-unit : one-packet
display
stop-accounting-buffer
hwtacacs-scheme
Syntax
display stop-accounting-buffer hwtacacs-scheme hwtacacs-scheme-name
View
Any view
Parameter
hwtacacs-scheme hwtacacs-scheme-name: Displays information on buffered
stop-accounting requests related to the HWTACACS scheme specified by
hwtacacs-scheme-name, a character string not exceeding 32 characters, excluding
"?".
Description
Use the display stop-accounting-buffer command to view information on the
stop-accounting requests buffered in the switch.
Related command: reset stop-accounting-buffer, stop-accounting-buffer
enable, retry stop-accounting.
Example
# Display information on the buffered stop-accounting requests related to the
HWTACACS scheme "3com".
<SW8800> display stop-accounting-buffer hwtacacs-scheme 3com
%No accounting stop packet exists.