3Com 8807 - Sham-Link

754 CHAPTER 40: BGP/MPLS VPN CONFIGURATION COMMANDS
Description
Use the routing-table limit command to limit the route maximum in a
VPN-instance.
Use the undo routing-table limit command to cancel the limitation.
It is necessary to enter a VPN-instance sub-view before using the routing-table
command. Create a VPN-instance routing table in this view and allocate a route
distinguisher (RD) in either of the following formats:
16-bit ASN: A 32-bit user-defined number, for example, 100:1.
32-bit IP address: A 16-bit user-defined number, for example, 172.1.1.1:1.
Create a VPN-target extended community for a VPN-instance and specify ingress
or egress interface or both of them for the vpn-target command. These
parameters can be used to configure ingress/egress routing information of the
VPN-target extended community for a router.
Example
# Configure the maximum routes in VPN instance vpn1 to 1000.
[SW8800] ip vpn-instance vpn1
[3Com-vpn-vpn1] route-distinguisher 100:1
[3Com-vpn-vpn1] vpn-target 100:1 import-extcommunity
[3Com-vpn-vpn1] routing-table limit 1000 syslog-alert
sham-link Syntax
sham-link source-addr destination-addr [ cost cost-value ] [ dead seconds ] [
hello seconds ] [ md5 keyid key seconds ] [ retransimit seconds ] [ simple
passwor ] [ trans-delay seconds ]
undo sham-link source-addr destination-addr
View
OSPF area view
Parameter
source-addr: Source address of a Sham-link, a Loopback interface address with a
32-bit mask.
destination-addr: Destination address of a Sham-link, a Loopback interface
address with a 32-bit mask.
cost-value: Cost at Sham-link, in the range of 1 to 65535. By default, it is 1.
password: Authentication in plain text on the interface, 8 characters at most. It
must be consistent with the authentication of a Sham-link peer.
keyid: MD5 authentication identifier on the interface. The keyed is in the range of
1 to 255. It must be consistent with the authentication string of Sham-link peer.