3Com 8807 - Preference

676 CHAPTER 38: MBGP MULTICAST EXTENSION CONFIGURATION COMMANDS
undo peer { group-name | peer-address } route-policy policy-name import
View
IPv4 multicast sub-address family view
Parameter
group-name: Name of peer group.
peer-address: IP address of the peer.
policy-name: Name of the applied route policy.
Description
Use the peer route-policy import command to assign the Route-policy to the
route coming from the peer.
Use the undo peer route-policy import command to delete the specified
Route-policy.
By default, the peer has no Route-policy association.
The inbound route policy configured for the peer takes precedence over the
configurations for the peer group.
Related command: peer route-policy export.
Example
# Apply the Route-policy named test-policy to the route coming from the peer
group test.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] peer test route-policy test-policy import
preference Syntax
preference ebgp-value ibgp-value local-vlaue
undo preference
View
IPv4 multicast sub-address family view
Parameter
ebgp-value: EBGP route priority, in the range of 1 to 256. By default, it is 256.
ibgp-value: IBGP route priority, in the range of 1 to 256. By default, it is 256.
local-value: Local route priority, in the range of 1 to 256. By default, it is 130.
Description
Use the preference command to configure MBGP protocol priority.