3Com 8807 - Multicast Routing-Enable; Multicast-Suppression

594 CHAPTER 33: MULTICAST COMMON CONFIGURATION COMMANDS
multicast routing-enable Syntax
multicast routing-enable
undo multicast routing-enable
View
System view
Parameter
None
Description
Use the multicast routing-enable command to enable multicast routing.
Use the undo multicast routing-enable command to disable multicast routing.
By default, multicast routing is disabled.
Related commands: pim dm, pim sm, igmp enable.
Example
# Enable multicast routing.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] multicast routing-enable
multicast-suppression Syntax
multicast-suppression { ratio | bandwidth bandwidth }
undo multicast-suppression
View
Ethernet port view
Parameter
ratio: Maximum wire speed ratio of the multicast traffic allowed on the port. The
value range is 1 to 100, and the default value is 50. The smaller the ratio is, the
smaller the multicast traffic is allowed to pass.
bandwidth: Multicast suppression bandwidth on the port. The value range is 1 to
the maximum value of port bandwidth.
Description
Use the multicast-suppression command to set the multicast suppression ratio
or multicast suppression bandwidth.
Use the undo multicast-suppression command to disable the multicast
suppression function.
The default multicast suppression ratio is 100%.