3Com 8807 - Display Nqa; Destination-Ip

1074 CHAPTER 66: NQA CONFIGURATION COMMANDS
Use the undo description command to delete the configured description
information.
By default, there is no description information of the operation.
Example
# Describes the test group as "Cary’s icmp test".
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] description Cary’s icmp test
destination-ip Syntax
destination-ip ip-address
undo destination-ip
View
NQA test group view
Parameter
ip-address: Destination IP address of the test.
Description
Use the destination-ip command to configure the destination IP address of the
test.
Use the undo destination-ip command to delete the configured destination IP
address.
By default, no destination IP address of the test is configured.
The test can be performed only after the destination IP address is configured.
Example
# Set the destination IP address of the test to 192.168.80.80.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] destination-ip 192.168.80.80
display nqa Syntax
display nqa { results | history } [ administrator-name test-tag ]
View
Any view
Parameter
results: Displays the test results.
history: Displays the history test record information.