3Com 8807 - Dhcp Server Ip-Pool; Dhcp Server Nbns-List

830 CHAPTER 47: DHCP CONFIGURATION COMMANDS
Related command: dhcp server ip-pool, network, static-bind ip-address, and
dhcp server static-bind.
Example
# Forbid the IP addresses from 10.110.1.1 to 10.110.1.63 to be automatically
assigned.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] dhcp server forbidden-ip 10.110.1.1 10.110.1.63
dhcp server ip-pool Syntax
dhcp server ip-pool pool-name
undo dhcp server ip-pool pool-name
View
System view
Parameter
pool-name: Name of the address pool, a string that is of 1 to 64 characters in
length. An address pool name uniquely identifies an address pool.
Description
Use the dhcp server ip-pool command to create a global DHCP address pool and
enter the corresponding DHCP address pool view.
Use the undo dhcp server ip-pool command to remove a specified global DHCP
address pool.
No global DHCP address pool is created by default.
Related command: dhcp enable.
Example
# Create a global DHCP address pool with a name of 0.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] dhcp server ip-pool 0
[3Com-dhcp-0]
dhcp server nbns-list Syntax
In VLAN interface view:
dhcp server nbns-list ip-address [ ip-address ]
undo dhcp server nbns-list { ip-address | all }
In system view:
dhcp server nbns-list ip-address [ ip-address ] { interface vlan-interface vlan-id
[ to vlan-interface vlan-id ] | all }