3Com 8807 - Display Vlan-Protocol-Vlan Vlan; Port Hybrid Protocol-Vlan Vlan

Protocol-Based VLAN Configuration Commands 85
display
vlan-protocol-vlan vlan
Syntax
display protocol-vlan vlan { vlan-list | all }
View
Any view
Parameter
vlan-list: Specifies a VLAN list. It is expressed in the form of vlan-list = { vlan-id [ to
vlan-id ] }, where the vlan-id after the keyword to must be larger than or equal to
the vlan-id before to.
all: Displays the protocol information of all VLANs.
Description
Use the display protocol-vlan vlan command to view the protocol information
and protocol index configured for a VLAN, to which you can refer when you use
the protocol-based VLAN and add/delete a protocol.
Related command: display vlan.
Example
# Display the protocol information and protocol index configured on the VLAN
522.
<SW8800> display protocol-vlan vlan 522
VLAN ID: 522
VLAN Type: Protocol-based VLAN
Index Type Value
0 at
1 ethernetii etype 0x0600
2 llc dsap 0x1 ssap 0x02
3 snap etype 0x0700
4 ipx ethernetii
5 ipx llc
6 ipx raw
7 ipx snap
port hybrid
protocol-vlan vlan
Syntax
port hybrid protocol-vlan vlan vlan-id { vlan-protocol-list | all }
undo port hybrid protocol-vlan vlan { vlan-id { vlan-protocol-list | all } | all }
View
Ethernet port view
Parameter
vlan-id: ID of the VLAN which a protocol is added to or deleted from.
{ vlan-protocol-list | all }: vlan-protocol represents the VLAN protocol list to be
added to or deleted from a certain port, in the form of vlan-protocol-list = {
protocol-index [ to protocol-end ] }. protocol-index indicates the initial value of
protocol index; protocol-end indicates the end value of protocol index.