3Com 8807 - Nbns-List; Netbios-Type

844 CHAPTER 47: DHCP CONFIGURATION COMMANDS
Example
# Configure an outbound gateway with an IP address of 10.110.1.99 for DHCP
clients of global DHCP address pool 0.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] dhcp server ip-pool 0
[3Com-dhcp-0] gateway-list 10.110.1.99
nbns-list Syntax
nbns-list ip-address [ ip-address ]
undo nbns-list { ip-address | all }
View
DHCP address pool view
Parameter
ip-address: IP address of a NetBIOS server. You can specify up to eight IP addresses
(separated by spaces) in one command.
all: Specifies all configured NetBIOS server IP addresses.
Description
Use the nbns-list command to configure one or more NetBIOS server addresses
for a global DHCP address pool.
Use the undo nbns-list command to remove one or all NetBIOS server addresses
configured for a global DHCP address pool.
By default, no NetBIOS server address is configured for a global DHCP address
pool.
With eight NetBIOS server addresses already configured, if you add a new NetBIOS
server address by executing the nbns-list command, the new one overwrites the
oldest one.
Related command: dhcp server ip-pool, dhcp server nbns-list, netbios-type.
Example
# Configure a NetBIOS server with an IP address of 10.12.1.99 for the global
DHCP address pool named 0.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] dhcp server ip-pool 0
[3Com-dhcp-0] nbns-list 10.12.1.99
netbios-type Syntax
netbios-type { b-node | h-node | m-node | p-node }
undo netbios-type