3Com 8807 - Ntp-Service Authentication Enable; Ntp-Service Authentication-Keyid

NTP Configuration Commands 933
# Give the authority of time request and query control of the local equipment to
the peer in ACL 2000.
[SW8800] ntp-service access synchronization 2000
ntp-service
authentication enable
Syntax
ntp-service authentication enable
undo ntp-service authentication enable
View
System view
Parameter
None
Description
Use the ntp-service authentication enable command to enable the NTP-service
authentication function.
Use the undo ntp-service authentication enable command to disable this
function.
By default, the authentication is disabled.
Example
# Enable NTP authentication function.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] ntp-service authentication enable
ntp-service
authentication-keyid
Syntax
ntp-service authentication-keyid number authentication-mode md5 value
undo ntp-service authentication-keyid number
View
System view
Parameter
number: Key number, ranging from 1 to 4,294,967,295.
value: Value of the key with 1 to 16 ASCII characters.
Description
Use the ntp-service authentication-keyid command to set NTP authentication
key.
Use the undo ntp-service authentication-keyid command to cancel the NTP
authentication key.