3Com 8807 - Display Link-Aggregation Summary; Display Link-Aggregation Verbose

152 CHAPTER 11: ETHERNET LINK AGGREGATION CONFIGURATION COMMANDS
display link-aggregation
summary
Syntax
display link-aggregation summary
View
Any view
Parameter
None
Description
Use the display link-aggregation summary command to view summary
information of all aggregation groups, including local device ID, aggregation
group ID, aggregate group type, peer device ID, number of Selected ports, number
of Standby ports, load sharing type and master port number.
Example
# Display summary information of all aggregation information.
<SW8800> display link-aggregation summary
Aggregation Group Type:D -- Dynamic, S -- Static , M -- Manual
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor ID: 0x8000, 00e0-fc23-0d90
AL AL Partner ID Select Standby Share Master
ID Type Ports Ports Type Port
--------------------------------------------------------------------
------------
1 M none 2 0 Shar GigabitEthernet3/1/1
3 M none 4 0 Shar Ethernet4/1/45
display link-aggregation
verbose
Syntax
display link-aggregation verbose [ agg-id ]
Tabl e 20 Description on the fields of the display lacp system-id command
Field Description
Actor System ID The device ID of the local system, including system priority and system MAC
address.
Tabl e 21 Description on the fields of the display link-aggregation summary command
Field Description
Actor ID Local device ID
AL ID Aggregation group ID
AL Type Aggregation group type
Partner ID Peer device ID
Select Ports Number of selected ports
Standby Ports Number of standby ports
Share Type Load sharing type
Master Port Master port number