86 CHAPTER 4: VLAN CONFIGURATION COMMANDS
all: Adds/deletes all protocols to/from a port.
Description
Use the port hybrid protocol-vlan vlan command to add a protocol VLAN or
protocol VLANs to a specified port.
Use the undo port hybrid protocol-vlan vlan command to delete a protocol
VLAN or protocol VLANs from the port.
Use the undo port hybrid protocol-vlan vlan all command to delete all the
configured protocol VLANs from the port.
n
■ Only Hybrid ports support this feature at present.
■ The specified port must belong to the VLAN before a protocol VLAN can be
added to it.
Related command: display protocol-vlan vlan { vlan-list | all }.
Example
# Add protocol VLANs 4 to 7 to Ethernet1/1/1.
[3Com-Ethernet1/1/1] port hybrid protocol-vlan vlan 3 4 to 7
protocol-vlan Syntax
protocol-vlan [ protocol-index ] { at | ipx { ethernetii | llc | raw | snap } | mode {
ethernetii [ etype etype-id ] | llc [ dsap dsap-id ] [ ssap ssap-id ] | snap [ etype
etype-id ] } }
undo protocol-vlan { protocol-index [ to protocol-end ] | all }
View
VLAN view
Parameter
protocol-index: Initial value of protocol index, ranging from 0 to 7. It must be
smaller than protocol-end.
protocol-end: End value of protocol index, ranging from 0 to 7
at: AppleTalk-based VLAN. Encapsulation format is EthernetII, and the Ethernet
type is 0x809B.
ipx: IPX-based protocol VLAN, encapsulated in three formats: Ethernetii, LLC, and
SNAP.
ethernetii: Encapsulation format is EthernetII, and the Ethernet type is 0x8137.
llc: Encapsulation format is LLC, DSAP=SSAP=0xE0.
snap: Encapsulation format is SNAP, and the Ethernet type is 0x8137.
raw: LLC-encapsulated IPX packet format of Novell, DSAP=SSAP=0xFF.
To Next Page
Loading...
