60
INFORMATION CENTER
Information Center
Configuration
Commands
display channel Syntax
display channel [ channel-number | channel-name ]
View
Any view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels.
channel-name: Specifies the channel name. the name can be channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,
trapbuffer, logfile.
Description
Use the display channel command to view the details about the information
channel.
Without parameter, the display channel command shows the configurations of
all the channels.
Example
# Show details about the information channel 0.
<SW8800> display channel 0
channel number:0, channel name:console
MODU_ID NAME ENABLE LOG LEVEL ENABLE TRAP LEVEL ENABLE
DEBUGGING LEVEL
0xffff0000 default Y warning Y debugging Y debugging
display info-center Syntax
display info-center
View
Any view
Parameter
None
To Next Page
Loading...
