3Com 8807 - Mac-Address

162 CHAPTER 12: MAC ADDRESS TABLE MANAGEMENT COMMANDS
dynamic: Dynamic table entry, which will be aged.
interface-type: Specifies the interface type.
interface-number: Specifies the interface number.
count: the display information will only contain the sum number of MAC
addresses in the MAC address table if user choice this parameter when using this
command.
Description
Use the display mac-address command to view MAC address table information.
When managing the Layer-2 addresses of the switch, the administrator can
perform this command to view such information as the Layer-2 address table,
address status (static or dynamic), Ethernet port of the MAC address, VLAN of the
address, and system address aging time.
Related command: mac-address, mac-address timer.
Example
# Show the information of the entry with MAC address at 00e0-fc01-0101
<SW8800> display mac-address 00e0-fc01-0101
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
00e0-fc01-0101 1 Learned Ethernet1/1/1 300
mac-address Syntax
mac-address { static | dynamic } mac-addr interface interface-type
interface-number vlan vlan-id
undo mac-address [ static | dynamic ] [ mac-addr [ interface interface-type
interface-number vlan vlan-id | interface interface-type interface-number | vlan
vlan-id ]
View
System view
Parameter
static: Static table entry, lost after resetting switch.
dynamic: Dynamic table entry, which will be aged.
mac-addr: Specifies the MAC address.
Tabl e 24 Description on the fields of the display mac-address command on display
Field Description
MAC ADDR The destination MAC address
VLAN ID The VLAN of the MAC address
STATE The state of the item, which can be Learned, Config static
PORT INDEX The forwarding port
AGING TIME(s) The aging time