3Com 8807 - Display Pim Rp-Info

626 CHAPTER 36: PIM CONFIGURATION COMMANDS
null: Specifies the incoming interface type as Null.
dense-mode: Specifies the multicast routing protocol as PIM-DM.
sparse-mode: Specifies the multicast routing protocol as PIM-SM.
Description
Use the display pim routing-table command to view the contents of the PIM
multicast routing table. The displayed information of the PIM multicast routing
table includes the SPT and RPF information.
Example
# View the contents of the PIM multicast routing table on the router.
<SW8800> display pim routing-table
PIM-SM Routing Table
Total 0 (*,*,RP)entry, 0 (*,G)entry, 2 (S,G)entries
(192.168.1.2, 224.2.178.130),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
(192.168.1.2, 224.2.181.90),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
Total 2 entries listed
display pim rp-info Syntax
display pim rp-info [ group-address ]
View
Any view
Parameter
group-address: Group address to display. If no multicast group is specified, the RP
information about all multicast groups will be displayed.
Description
Use the display pim rp-info command to view the RP information of multicast
group.
Tabl e 90 Description on the fields of display pim routing-table
Field Description
RP Rendezvous Point
(S,G) (source address, multicast group)
PIM-SM PIM Sparse Mode
SPT Shortest Path Tree
RPF Reverse Path Forwarding