CCC Configuration Commands 763
View
Any view
Parameter
ccc-name: Name of the CCC connection whose information is to be displayed.
type local: Displays information about the local CCC connections only.
type remote: Displays information about the remote CCC connections only.
Description
Use the display ccc command to display the information about specified CCC
connections.
Example
# Display information about the CCC connection named c-link.
<SW8800> display ccc c-link
name: c-link, type: remote, state: down,
intf: Vlan-interface1003 (down), tran-lsp: ccc2 (up), rcv-lsp: ccc1 (up)
static-lsp egress l2vpn Syntax
static-lsp egress lsp-name l2vpn incoming-interface vlan-interface vlan-id
in-label in-label
undo static-lsp egress lsp-name
View
MPLS view
Parameter
lsp-name: Name of the label switching path (LSP).
vlan-id: ID of the VLAN whose interface is to be used to create the LSP.
in-label-value: Value of the in-label, ranging from 16 to 1,023.
Description
Use the static-lsp egress l2vpn command to create a static L2VPN LSP for the
egress label switching router (LSR).
Use the undo static-lsp egress command to remove a L2VPN LSP created for the
egress LSR.
You need to create two LSPs (for transmitting and receiving) before creating a
remote CCC connection.
Related command: static-lsp ingress l2vpn, static-lsp transit l2vpn,
debugging mpls.
Example
# Create a static LSP named bj-sh on the egress LSR.
To Next Page
Loading...
