884 CHAPTER 50: POE CONFIGURATION COMMANDS
Example
# Enable the module in slot 2 to detect the compatibility of the PD connected to it.
[SW8800] poe legacy enable slot 2
# Disable the detection of the compatibility of the PD connected to the module in
slot 2.
[SW8800] undo poe legacy enable slot 2
poe max-power Syntax
poe max-power max-power
undo poe max-power
View
Ethernet port view
Parameter
max-power: Maximum power distributed to the port, ranging from 3000 mW to
16800 mW.
Description
Use the poe max-power command to set the maximum PoE power on the
current port.
Use the undo poe max-power command to restore the default PoE power on
current port.
By default, the maximum PoE power on a port is 16800 mW.
Example
# Set the maximum PoE power on the current port GigabitEthernet3/1/1 to
12,000 mW.
[3Com-GigabitEthernet3/1/1] poe max-power 12000
# Restore the default maximum PoE power on the current port
GigabitEthernet3/1/1.
[3Com-GigabitEthernet3/1/1] undo poe max-power
poe max-power slot Syntax
poe max-power max-power slot slot-num
undo poe max-power slot slot-num
View
System view
To Next Page
Loading...
