3Com 8807 - Peer Route-Policy Export

536 CHAPTER 27: BGP CONFIGURATION COMMANDS
View
BGP view
Parameter
group-name: Name of peer group.
Description
Use the peer reflect-client command to configure a peer group as the route
reflector client.
Use the undo peer reflect-client command to cancel the existing configuration.
By default, there is no route reflector in an AS.
This command only applies to IBGP peer groups.
Related command: reflect between-clients, reflector cluster-id.
Example
# Configure the peer group "test" as the route reflector client.
[3Com-bgp] peer test reflect-client
peer route-policy export Syntax
peer group-name route-policy route-policy-name export
undo peer group-name route-policy route-policy-name export
View
BGP view
Parameter
group-name: Name of peer group.
route-policy-name: The specified Route-policy.
Description
Use the peer route-policy export command to assign the Route-policy to the
routes advertised to the peer group.
Use the undo peer route-policy export command to delete the specified
Route-policy.
By default, the peer/peer group has no Route-policy association.
The peer route-policy export command only applies to peer groups.
Related command: peer route-policy import.
Example
# Apply the Route-policy named test-policy to the route going out of the peer
group test.