RIP Configuration Commands 399
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
No peer router
Network :
202.38.168.0
filter-policy export Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name } export [
routing-protocol ]
View
RIP view
Parameter
acl-number: Access control list number used for filtering the destination addresses
of the routing information.
ip-prefix-name: Name of address prefix list used for filtering the destination
addresses of the routing information.
routing-protocol: Routing protocol whose routing information is to be filtered,
including direct, isis, bgp, ospf, ospf-ase, ospf-nssa and static at present.
Description
Use the filter-policy export command to configure to filter the advertised
routing information by RIP.
Use the undo filter-policy export command to configure not to filter the
advertised routing information.
By default, RIP does not filter the advertised routing information.
Tab le 53 Description of the fields of the display rip command
Field Description
RIP is running RIP is active
public net VPN-Instance Public network in the VPN
Checkzero is on Enable zero field checking
Default cost : 1 The default route cost is 1
Summary is on Routes are summarized automatically
Preference : 100 The preference of RIP is 100
Traffic-share is off Load balancing state for the interface
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
Three timers of RIP
No peer router No destination address of a transmission is
specified
Network :202.38.168.0 Enable RIP on network segment 202.38.168.0
To Next Page
Loading...
