358 CHAPTER 21: AAA AND RADIUS/HWTACACS PROTOCOL CONFIGURATION COMMANDS
View
HWTACACS view
Parameter
ip-address: Source IP address, in dotted decimal format.
Description
Use the nas-ip command to set the source IP address for HWTACACS packets sent
from the NAS (switch), such that all the packets sent to the TACACS server carry
the same source IP address.
Use the undo nas-ip command to delete the configuration.
Specifying the source address for sending HWTACACS packet avoids the
unreachability of packet returned from the server when the physical interface fails.
Generally, the Loopback interface address is recommended.
By default, the source IP address of the packets is the IP address of the interface of
the VLAN to which the port connecting the server belongs.
Related command: display hwtacacs and hwtacacs nas-ip.
Example
# Configure the source IP address for HWTACACS packets sent from the NAS
(switch) to 10.1.1.1.
[SW8800] hwtacacs scheme test1
[3Com-hwtacacs-test1] nas-ip 10.1.1.1
primary accounting Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
format.
port-number: Port number of the server, which is in the range 1 to 65535 and
defaults to 49.
Description
Use the primary accounting command to configure a primary TACACS
accounting server.
Use the undo primary accounting command to delete the configured primary
TACACS accounting server.
By default, the IP address of the TACACS accounting server is all zeros.
To Next Page
Loading...
