952 CHAPTER 56: SSH TERMINAL SERVICE CONFIGURATION COMMANDS
Performing this command, you can enter the public key view. Then you can use
the public-key-code begin command to configure the client public key on the
server. The client public key is generated randomly by the SSH 2.0-enabled client
software.
Related command: public-key-code begin, public-key-code end.
Example
# Enter the public key view named sw8800002.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] rsa peer-public-key sw8800002
[3Com-rsa-public-key]
ssh server
authentication-retries
Syntax
ssh server authentication-retries times
undo ssh server authentication-retries
View
System view
Parameter
times: Number of authentication retries, in the range from 1 to 5. By default, the
value is 3.
Description
Use the ssh server authentication-retries command to set the number of SSH
connection authentication retries.
Use the ssh server authentication-retries command to restore the default
number of SSH connection authentication retries.
Related command: display ssh server.
Example
# Specify the number of login authentication retries as 4.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] ssh server authentication-retries 4
ssh server
compatible_ssh1x
enable
Syntax
ssh server compatible_ssh1x enable
undo ssh server compatible_ssh1x
View
System view
To Next Page
Loading...
