MBGP Multicast Extension Configuration Commands 665
undo import-route protocol
View
IPv4 multicast sub-address family view
Parameter
protocol: Source routing protocols that can be imported, which can be direct,
ospf, ospf-ase, ospf-nssa, rip, isis and static.
med-value: Metric value loaded by an imported route, ranging from 0 to
4,294,967,295.
route-policy-name: Route policy used for importing routes.
Description
Use the import-route command to import routing information of other protocols
into MBGP.
Use the undo import-route command to cancel the importing.
By default, MBGP will not import routing information of other protocols.
Example
# Import static routes.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] import-route static
ipv4-family multicast Syntax
ipv4-family multicast
undo ipv4-family multicast
View
BGP view, VPN instance sub-address family view, VPNv4 sub-address family view
Parameter
None
Description
Use the ipv4-family multicast command to enter the IPv4 multicast sub-address
family view.
Use the undo ipv4-family multicast command to exit the IPv4 multicast
sub-address family view, return to the unicast view and remove all the information
in multicast.
Example
# Enter the IPv4 multicast sub-address family view.
To Next Page
Loading...
